Clean Evf Screen - RED EPIC-M DRAGON (Carbon Fiber) Operation Motion

EPIC/SCARLET OPERATION GUIDE
RED recommends using a Delkin Devices Digital Duster Kit (or equivalent) to clean the sensor or OLPF.
WARNING: Clean the camera sensor AT YOUR OWN RISK. The camera sensor is covered by a layer of protective
glass, but will not protect the sensor from improper care. Damage to the sensor caused by improper handling is NOT
covered under warranty. If the sensor becomes dirty, contact your Bomb Squad representative.
WARNING: Handle the DSMC interchangeable OLPFs carefully. DO NOT touch the OLPF glass. Failure to follow
proper instructions may scratch or damage the OLPF.

CLEAN EVF SCREEN

NOTE: This section describes only how to clean the screen on the DSMC2™ RED EVF, and not how to clean the
entire device.
This section explains how to clean the screen on the DSMC2 RED EVF. The screen is accessed by removing the
DSMC2 RED EVF Modular Optical Block.
Use an ionized rubber air bulb to clean the screen on the DSMC2 RED EVF. If there are still particles on the screen
after using an air bulb, gently wipe the screen with a rolled-up, particulate-free, non-abrasive optical-grade wipe.
NOTE: Cleaning the screen without first removing solid particles increases the risk of scratching the screen. As with
many screens, any type of physical contact with the screen may scratch the surface.
PROHIBITED EVF SCREEN CLEANERS
DO NOT use any of the items listed below to clean the screen on the DSMC2 RED EVF. These products have not
been tested on RED products and may cause damage or streaking.
Compressed air
Gas dusters
Solvents
Rubbing alcohol
Isopropyl alcohol
®
Windex
Third-party cleaning kits
Pre-packaged lens cleaner containing any additives, such as detergent, anti-static compounds, or fragrance
RED Microfiber Bag
WARNING: Damage to any screens or other components of the camera system caused by using prohibited cleaners
is not covered under warranty.
C O PYR I G HT © 2 0 1 6 R ED.C O M , I NC 9 5 5 - 0 0 2 0 _V 6 .3 , R EV - F | 1 9 0