Record - RED EPIC-M DRAGON (Carbon Fiber) Operation Motion

EPIC/SCARLET OPERATION GUIDE

RECORD

Perform one of the following actions to begin recording:
Press PWR/REC on the camera.
Press REC on an attached side SSD module.
Press REC on an attached DSMC Side Handle.
Double-tap the right 25% on an attached touchscreen display (when enabled).
NOTE: To enable Double- Tap Right 25% to Record, go to Menu > Settings > Display > Monitor Control >
Advanced > Gestures.
RECORD VIA HD-SDI OR HDMI
NOTE: HD- SDI and HDMI ports are only available on select DSMC2 expanders. For more information, go to
"Input/Output Connectors" on
NOTE: The secondary LCD/EVF port (on the side of the camera) and the HDMI port cannot be used at the same time.
For more information, go to
This section describes how to record via HD-SDI or HDMI through simultaneous record (recording to an SSD and an
external recorder at the same time) or external record only. For more information on how to enable default menus for a
external recorder, go to "Cannot Use Touchscreen or DSMC Side Handle" on
SIMULTANEOUS RECORD
NOTE: HD- SDI and HDMI ports are only available on select DSMC2 expanders. For more information, go to
"Input/Output Connectors" on
You can record simultaneously to an external recorder and a RED SSD. To record simultaneously, follow the
instructions below:
1. Connect the camera to an external recorder with an HD-SDI or HDMI cable.
2. Ensure an SSD is inserted in the camera and formatted.
3. Set up the HD-SDI or HDMI output:
A. Go to Menu > Settings > Display > Monitor Control > Monitor Setup.
B. Select HDMI or HDSDI from the drop-down menu at the top of the menu.
C. Select Clean from the Mode drop-down menu (otherwise the external recorder records the overlay).
D. Select the output resolution from the Resolution drop-down menu.
NOTE: The HDMI and HD-SDI maximum resolution is 1080p. For more information, go to
Ports" on page 223.
4. Disable all False Colors (otherwise the external recorder records the False Colors):
A. Go to Menu > Settings > Display > Tools.
B. Select Off from the False Color drop-down menu.
5. If monitoring audio via a third-party monitor that supports audio, set up the monitor mix:
A. Go to Menu > Settings > Audio > Mix > Monitor Mix.
B. Adjust the input channels.
6. Go to Menu > Settings > Recording > Mode.
7. Select Local from the Storage drop-down menu.
8. Begin recording.
C O PYR I G HT © 2 0 1 6 R ED.C O M , I NC
page 221.
"Advanced" on page 91.
page 221.
page 196.
"Record/Monitor Out
9 5 5 - 0 0 2 0 _V 6 .3 , R EV - F | 5 6