Power Ports; Ssd Module Connectors - RED EPIC-M DRAGON (Carbon Fiber) Operation Motion

EPIC/SCARLET OPERATION GUIDE

POWER PORTS

DC IN (POWER INPUT)
The 6-pin 1B LEMO connector accepts DC input power from 11.5 V DC to 17 V DC. A built-in power conditioner
protects against reverse- polarity connections, electrostatic discharge (ESD), undervoltage, overvoltage, and
overcurrent.
WARNING: Both pairs of +VBATT and GROUND pins must be wired. Using a third-party power cable that wires only
one (1) pair of +VBATT and GROUND pins may damage the power supply or the camera. Damage to the power
supply or other components of the camera system caused by using an inappropriate power cable is not covered
under warranty.
Figure: Front Face of the DC In Power Input Connector (Looking at the Camera)
PIN
1
2
3
4
5
6
NOTE: Mating connector is FGJ.1B.306.CWLD72Z.
COMPATIBLE CABLES
790-0138: RED 2B-to-1B LEMO Power Adaptor Cable
790-0164: XLR Power Cable (10')
790-0165: XLR Power Cable (30")

SSD MODULE CONNECTORS

The connectors for the side SSD modules and the Rear SSD Module are described in the
Guide, available at www.red.com/downloads.
C O PYR I G HT © 2 0 1 6 R ED.C O M , I NC
6-PIN 1B DC INPUT CONNECTOR
SIGNAL DESCRIPTION
+VBATT Power input, +11.5 to +17 V DC
+VBATT Power input, +11.5 to +17 V DC
SCL-BATT Serial battery bus clock
GROUND Power return (camera ground)
GROUND Power return (camera ground)
SDA-BATT Serial battery bus data
DSMC Media Operation
9 5 5 - 0 0 2 0 _V 6 .3 , R EV - F | 2 3 0