Configure Your Camera - RED EPIC-M DRAGON (Carbon Fiber) Operation Motion

EPIC/SCARLET OPERATION GUIDE

CONFIGURE YOUR CAMERA

This section describes common options for configuring your camera system.
DSMC SIDE HANDLE: INSTALL/REMOVE
INSTALL THE DSMC SIDE HANDLE
WARNING: Before installing or removing this item, you MUST turn off the camera.
REQUIRED TOOLS: T10 TORX
1. Turn off the camera.
2. Use a T10 TORX driver to remove the single screw located at the bottom of the BRAIN side plate (if the side plate
is installed).
3. Rotate the BRAIN side plate upwards to disengage the lip at the top of the side plate from the camera, and
remove the BRAIN side plate.
4. Insert the lip on the DSMC Side Handle into the slot where the lip of the BRAIN side plate was installed.
5. Press the DSMC Side Handle down flush along the side of the camera.
6. Rotate the thumbscrew upward while applying steady pressure until tight.
REMOVE THE DSMC SIDE HANDLE
WARNING: Before installing or removing this item, you MUST turn off the camera.
REQUIRED TOOLS: T10 TORX driver
1. Turn off the camera.
2. Rotate the thumbscrew downward until the DSMC Side Handle detaches from the camera body.
3. Disengage the tension lip on the DSMC Side Handle by pulling the bottom away from the camera.
4. Insert the tension lip on the BRAIN side plate into the recess on the side of the camera.
5. Install the appropriate screw at the bottom of the BRAIN side plate using a T10 TORX driver. DO NOT exceed 70
in-oz, or damage may occur.
EPIC side plate screw: M3x0.5 x 8 mm
SCARLET side plate screw: M3x0.5 x 5.5 mm
WARNING: DO NOT OVERTIGHTEN.
C O PYR I G HT © 2 0 1 6 R ED.C O M , I NC
®
driver
9 5 5 - 0 0 2 0 _V 6 .3 , R EV - F | 4 2