Table of Contents
Advertisement
EPIC/SCARLET OPERATION GUIDE
LIMITER
Select the Limiter check box to add a limiter to the analog input signal chain. Use the limiter in dynamic environments
where external mixers are not practical for controlling signal strength. The limiter is only available with analog audio
input.Pre-Amp
The pre-amplifier range is 30 dB to 60 dB. The default is 32 dB. To adjust amplification levels, follow the instructions
below:
1. Go to Menu > Settings > Audio > Pre-Amp.
2. Move the Pre-Amp (pre-amplifier) sliders up and down to adjust the amplification levels.
3. To link the amplification for each channel, go to Menu > Settings > Audio > Channel and select the Gain Sliders
check box. For more information, go to
AUDIO OUTPUT OPTIONS
DSMC BRAIN: One (1) 2-channel headphone output. For maximum quality, use high impedance headphones.
Pro I/O Module: One (1) XLR connector that supports 2-channel line level analog output. The signal strength of the
line out cannot be controlled, and is fixed at –15 dB gain.
HDMI and HD-SDI monitor: Both output two (2) channels of 24-bit 48 KHz uncompressed, embedded digital
audio. Select and mix the stereo channels in the Monitor Mix menu at Menu > Settings > Audio > Monitor Mix.
To monitor audio via HDMI or HD-SDI, the third-party monitor must support audio.
CONTROL HEADPHONE VOLUME (BRAIN)
The volume range for Left and Right is –28 dB to –0 dB. The default is –9 dB. To adjust headphone volume, use the
following instructions:
1. Go to Menu > Settings > Audio > Headphone.
2. Move the Headphone sliders up and down to adjust the volume.
3. To toggle mute/unmute, select ACTIVE and MUTE, respectively.
4. To link the volume for Left and Right, go to Menu > Settings > Audio > Channel and select the Volume Sliders
check box. For more information, go to
Figure: Headphone Volume
C O PYR I G HT © 2 0 1 6 R ED.C O M , I NC
"Link" on the previous
page.
"Link" on the previous
page.
9 5 5 - 0 0 2 0 _V 6 .3 , R EV - F | 1 5 5
Hide quick links:
Advertisement
Table of Contents
