Genlock - RED EPIC-M DRAGON (Carbon Fiber) Operation Motion

EPIC/SCARLET OPERATION GUIDE

GENLOCK

Generator locking (genlock) is a tri-level signal used to synchronize video and audio systems. Genlock is based on
SMPTE 296M and 274M.
There are two (2) important genlock sync modes:
Monitor Sync
Sensor Sync
NOTE: For genlock to function correctly, the cameras must be on the same firmware version, and must be using the
same project time base and recording frame rate.
MONITOR SYNC
Monitor Sync occurs when a genlock signal is provided that is compatible with the current monitor output frequency.
Monitor Sync is achievable even if the camera is using another form of synchronization to sync the camera sensor.
1. Connect the genlock device to the camera:
Connect the SYNC port on the camera to the device (green BNC) using a 3BNC-to-00 LEMO Sync Cable.
2. Go to Menu > Settings > Display > Monitor Control > Monitor.
3. Select BRAIN HDSDI from the drop-down menu.
4. Select the desired monitor output frequency from the Frequency drop-down menu. Select Auto to automatically
match the HD-SDI output to the current Project Time Base.
Monitor Sync is achieved automatically when a genlock signal is provided that is compatible with the current
monitor output frequency. When Monitor Sync is achieved, the GEN indicator in the Lower Status Row illuminates
green.
Figure: HD-SDI Output Frequency
REQUIRED CABLE
790-0154: 3BNC-to-00 LEMO Sync Cable
C O PYR I G HT © 2 0 1 6 R ED.C O M , I NC 9 5 5 - 0 0 2 0 _V 6 .3 , R EV - F | 1 7 2