Mounting The Expansion Ksu - Toshiba Strata DK40 Installation & Maintenance Manual

DK40 Installation
7. Connect applicable wiring (e.g., modular line cords, CW1308 cable connections, 25-
pair amphenol connector
wiring to the unit with the tie wrap that comes with the Base KSU
Remove amphenol connector clamp from plastic bag that comes with the Base KSU.
Fasten the clamp to hold the amphenol connector.
8. Ensure that the Ferrite core supplied is fitted to the Amphenol connector.
8 on Page
9. Connect Reserve batteries and plug battery cable into BATT connector of the KPSU16
power supply (see
10. If the Expansion KSU is going to be installed, refer to
on Page
11. Plug the AC power cable into an outlet and then turn ON the power supply switch.
12. Reinstall the front and side covers onto the Base KSU.

Mounting the Expansion KSU

Important!
Boxes
Expansion KSU
(bottom)
WARNING!
To mount the Expansion KSU
1. Make sure the side cover is removed from the Base KSU. Turn Base KSU DC power
switch OFF.
2. Set the Expansion KSU on the Base KSU's hinge mounts, making sure that the
Expansion KSU sets properly in place.
3. Remove the safety lock from plastic bag that comes with the Expansion KSU. Install
safety lock to the Base KSU as shown.
4. Pull out on the safety lock until it can no longer be moved, securing the Expansion KSU
to the Base KSU. Do not detach the lock from the Base KSU.
5. Connect the Expansion KSU ribbon cable to the connector on the Base KSU. Close
ribbon cable connector lock on Base KSU.
supplied is fitted as per
6. Connect Expansion KSU green/yellow earth wire plug (FG2) to TB1 of the Base KSU.
(Make sure the plug locks on FG2.)
7. Making sure that the Expansion KSU is flush against the mounting surface, mark the
location of the Expansion KSU mounting screw hole.
2-8
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
cable–see Figure
2-13).
"Reserve Power Option" on Page
2-8. If not, proceed to Step 1.
For purposes of identification, the following labels appear on the boxes and
Expansion KSUs:
DK40
DKSUE40A
Model DKSU40A
Strata DK40
To prevent electrical shock, make sure the power supply
switch is turned OFF.
Figure 2-9.
KSU Mounting Considerations
2-28) to the Base KSU and then fasten
2-17).
"Mounting the Expansion KSU"
See Figure 2-3.
See Figure 2-9.
See Figure 2-10. (Ensure that the Ferrite core
See Figures 2-5 and 2-9.
See Figure
Strata DK40 I&M Manual Spring 1999
(see Figure 2-8).
(See Figure 2-
2-3.