Toshiba Strata DK40 Installation & Maintenance Manual page 181

Hide thumbs Also See for Strata DK40:
Table of Contents

Advertisement

Telephone Upgrades
Notes
Digital telephones cannot be equipped with a DVSU and integrated data interface unit
(RPCI-DI) or DADMs at the same time.
Program 03, Code 62 or 64 must be set for the PDKU for telephones that are to receive
Speaker OCA and Program 31 LED 03 must be turned ON for telephone ports.
DVSU is not necessary to receive handset OCA.
DVSU Upgrade Installation
Figure 5-5
1.
Loosen the four captive screws securing the telephone base
the base.
2.
Loosen the four captive screws securing the metal plate to the standoffs inside the base
where the DVSU will be installed
3.
Position the DVSU PCB on the standoffs), and secure with the four provided screws.
4.
If installing the DVSU into a 2000-series digital telephone,
then connect the DVSU wire plugs to the DVSU connectors on the PCB inside the
telephone.
5.
Reinstall the telephone base and secure it with its four captive screws.
Note
Strata DK40 I&M Manual Spring 1999
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
Red Wire
DVSU Installation for Digital Telephones
The DKT2001-F will not support the DVSU.
Red
Wire
1483
(see Figure
5-5). Remove and discard the plate.
Station Apparatus
(see Figure
5-1) and remove
see Figures 5-6
or 5-7, and
5-9

Advertisement

Table of Contents
loading

Table of Contents