Piou, Pious Programming - Toshiba Strata DK40 Installation & Maintenance Manual

PIOU, PIOUS Option Interface Units

PIOU, PIOUS Programming

Program 03: Specify Code 41 or 42 for the slot that will support a PIOU or PIOUS.
Chapter 6 – Peripheral Installation, "Multiple PIOU, PIOUS Installation" on Page 6-59
more details)
Program 10-2: Activates External Page with All Call Page (with access code #39 only, not
with $OO &DOO 3DJH button).
Program *11: Assigns a CPN to route calls to the IMDU (digital lines only).
Program 60: Assigns SMDR options.
Program 77-1: Assigns relay control and IMDU options.
Program 78: Sets Night Ringing over External Page and assigns which exchange lines are to
access the IMDU .
Table 3-3 PIOU Controls, Indicators, and Connectors
Control/Indicator/Connector
SMDR/TTY interface connector J3
IMDU connector P1
IMDU connector P2
IMDU connector P3
M/B make/break jumper plug P10
M/B make/break jumper plug P11
Alarm sensor N.O./N.C. jumper
plug P12
CCITT/BELL jumper plug P13
SMDR baud rate switch SW1
TTY baud rate switch SW2
Modem/TTY switch SW3
SPO/SPI internal/external amplifier
switch SW4
Volume control VR1
P15
Strata DK40 I&M Manual Spring 1999
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
Type of Component
Dual modular
connector
10-pin connector
9-pin connector
3-pin connector
Wire jumper
2-position slide switch
2-position locking
push-button switch
2-position slide switch
Trim potentiometer
3-pin jumper
DK40 Universal Slot PCBs
Description
Interface connector for SMDR printer/call
accounting device and maintenance
terminal/modem.
Interface connector for remote
maintenance modem piggy-back module.
External Page/Door Lock Control Relay
Make or Break jumper plug.
Night/Hold Relay Make or Break jumper.
Alarm sensor normally open or closed
jumper.
IMDU or external modem operating
specification jumper plug. UK operation
must be CCITT.
Selects baud rate (300 or 1200 bps) for
SMDR printer or call accounting device.
Selects baud rate (300 or 1200 bps) for
Remote Maintenance Modem piggy-back
module (IMDU) or external TTY jack.
Enables PIOU for operation with IMDU
modem or TTY jack.
Not used on DK40.
Not used on DK40.
A or Mu law switch. Must be set for A law
operation in th UK.
(See
for
3-13