LevelOne wbr-3408 User Manual page 12

For best Wireless reception and performance, the Wireless
Router should be positioned in a central location with mini-
mum obstructions between the Wireless Router and the
PCs.
Also, if using multiple Access Points, adjacent Access
Points should use different Channels.
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the Wire-
less Router. Both 10BaseT and 100BaseT connections can be used
simultaneously.
If required, connect any port to a normal port on another Hub, using a standard
LAN cable. Any LAN port on the Wireless Router will automatically function as an
"Uplink" port when required.
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the Wireless Router. Use
the cable supplied with your DSL/Cable modem. If no cable was supplied, use a
standard cable.
4. Power Up

Power on the Cable or DSL modem.

Connect the supplied power adapter to the Wireless Router and power up.
Use only the power adapter provided. Using a different one may cause hardware
damage
5. Check the LEDs

The Power LED should be ON.

The Status LED should flash, then turn Off. If it stays on, there is a hardware error.

For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the
PC is also ON.)

The WAN LED should be ON.

The WLAN LED should be ON
For more information, refer to Front-mounted LEDs in Chapter 1.
12
Installation