LevelOne wbr-3408 User Manual page 15

If you can't connect
If the Wireless Router does not respond, check the following:

The Wireless Router is properly installed, LAN connection is OK, and it
is powered ON. You can test the connection by using the "Ping" com-
mand:

Open the MS-DOS window or command prompt window.

Enter the command:
ping 192.168.0.1
If no response is received, either the connection is not working, or
your PC's IP address is not compatible with the Wireless Router's IP
Address. (See next item.)

If your PC is using a fixed IP Address, its IP Address must be within the
range 192.168.0.2 to 192.168.0.254 to be compatible with the Wireless
Router's default IP Address of 192.168.0.1. Also, the Network Mask
must be set to 255.255.255.0. See Chapter 4 - PC Configuration for de-
tails on checking your PC's TCP/IP settings.

Ensure that your PC and the Wireless Router are on the same network
segment. (If you don't have a router, this must be the case.)

Ensure you are using the wired LAN interface. The Wireless interface
can only be used if its configuration matches your PC's wireless set-
tings.
15
Setup