Copying Crash Log Data Content To A Destination Device - ProCurve 6200yl Management And Configuration Manual

File Transfers
Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
A-34
Syntax: copy crash-data [<slot-id | master>] tftp <ip-address> <filename>
copy crash-data [<slot-id | master>] usb <filename>
copy crash-data [<slot-id | master>] xmodem
where: slot-id = a - h, and retrieves the crash log or crash data from
master
These commands copy the crash data content to a remote host,
attached USB device, or to a serially connected PC or UNIX
workstation. You can copy individual slot information or the
master switch information. If you do not specify either, the
command defaults to the master data.
For example, to copy the switch's crash data to a file in a PC:
Figure A-13. Example of Copying Switch Crash Data Content to a PC

Copying Crash Log Data Content to a Destination Device

Syntax: copy crash-log [<slot-id | master>] tftp <ip-address>
<filepath and filename>
copy crash-log [<slot-id | master>] usb <filename>
copy crash-log [<slot-id | master>] xmodem
where: slot-id = a - h, and retrieves the crash log from
master
the processor on the module in the specified slot.
Retrieves crash log or crash data from the switch's
chassis processor.
the processor on the module in the specified slot.
Retrieves the crash log from the switch's
chassis processor.