ProCurve 6200yl Management And Configuration Manual page 366

Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
14-22
Syntax: snmp-server host < community-string > < ip-address >
Using community name and destination IP address, this
command designates a destination network-
management station for receiving SNMP event log
messages from the switch. If you do not specify the event
level, then the switch does not send event log messages
as traps. You can specify up to 10 trap receivers (network
management stations).
Note: In all cases, the switch sends any threshold trap(s)
to the network management station(s) that explicitly set
the threshold(s).
[<none | all | non-info | critical | debug>]
Options for sending switch Event Log messages to a trap
receiver. Refer toTable 14-1, "Options for Sending Event
Log Messages as Traps," on page 14-22. The levels
specified with these options apply only to Event Log
messages, and not to threshold traps.
Table 14-1. Options for Sending Event Log Messages as Traps
Event Level Description
None (default) Send no log messages.
All Send all log messages.
Not INFO Send the log messages that are not information-only.
Critical Send critical-level log messages.
Debug Reserved for HP-internal use.
For example, to configure a trap receiver in a community named "red-team"
with an IP address of 10.28.227.130 to receive only "critical" log messages:
ProCurve(config)# snmp-server trap-receiver red-team
10.28.227.130 critical