ProCurve 6200yl Management And Configuration Manual page 525

Mirror Session Identity from
the Source Switch (Session
1 on Both Switches)
Switch-D(config)# mirror endpoint 10.10.10.119 9300 10.10.30.2 port a15
Switch-D(config)# mirror endpoint 10.10.20.145 9300 10.10.30.2 port a15
Figure B-30. Example of Configuring Remote Mirroring from Switches A and B on the Destination Switch
4. Using the ACLs to select the traffic to mirror, configure mirroring sessions
for Telnet traffic entering switches A and B on VLANs 10 and 20. (Because
the sessions are on different switches, you can use the same session
number for both sessions if you want to.)
The following three figures illustrate the configuration steps on the mirroring
destination switch (switch D) and on the mirroring sources (switches A and
B). Since there is no need for a mirroring configuration on the intermediate
device (switch C), this device can be any switch (or router) supporting IPv4
operation.
Monitoring and Analyzing Switch Operation
Mirror Session Destination
IP Address
Traffic Mirroring
Mirror Session
Exit Port
B-65