Copying Software Images - ProCurve 6200yl Management And Configuration Manual

N o t e

Copying Software Images

Using the CLI commands described in this section, you can copy software
images from the switch to another device using tftp, xmodem or usb.
For details on how switch memory operates, including primary and secondary
flash, refer to Chapter 6, "Switch Memory and Configuration".
TFTP: Copying a Software Image to a Remote Host
Syntax: copy flash tftp < ip-addr > < filename >
This command copies the primary flash image to a TFTP
server.
For example, to copy the primary flash to a TFTP server having an IP address
of 10.28.227.105:
ProCurve# copy flash tftp 10.28.227.105 k0800.swi
where k0800.swi is the filename given to the flash image being copied.
Xmodem: Copying a Software Image from the Switch to a
Serially Connected PC or UNIX Workstation
To use this method, the switch must be connected via the serial port to a PC
or UNIX workstation.
Syntax: copy flash xmodem < pc | unix >
Uses Xmodem to copy a designated configuration file from the
switch to a PC or Unix workstation.
For example, to copy the primary flash image to a serially connected PC:
1. Execute the following command:
Procurve# copy xmodem flash
Press 'Enter' and start XMODEM on your host...
2. After you see the above prompt, press
3. Execute the terminal emulator commands to begin the file transfer.
Copying Software Images
[Enter] .
File Transfers
A-23