Viewing Port Utilization Statistics - ProCurve 6200yl Management And Configuration Manual

Hide thumbs Also See for 6200yl:

Table of Contents

ProCurve# show interface port-utilization

Viewing Port Utilization Statistics

Use the show interface port-utilization command to view a real-time rate display

for all ports on the switch. The following shows a sample output from this

Figure 10-5. Example of a Show Interface Port-Utilization Command Listing

Operating Notes:

For each port on the switch, the command provides a real-time display

of the rate at which data is received (Rx) and transmitted (Tx) in terms

of kilobits per second (KBits/s), number of packets per second (Pkts/

s), and utilization (Util) expressed as a percentage of the total band-

width available.

The show interfaces <port-list> command can be used to display the

current link status and the port rate average over a 5 minute period.

Port rates are shown in bits per second (bps) for ports up to 1 Gigabit;

for 10 Gigabit ports, port rates are shown in kilobits per second

Viewing Port Status and Configuring Port Parameters

Port Status and Configuration

Table of Contents

5400zl 3500yl