Copying Event Log Output To A Destination Device; Copying Crash Data Content To A Destination Device - ProCurve 6200yl Management And Configuration Manual

At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-11. Example of Sending Command Output to a File on an Attached PC
N o t e
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-12. Example of Sending Event Log Content to a File on an Attached PC
Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation
The command you specify must be enclosed in double-quote marks.

Copying Event Log Output to a Destination Device

Syntax: copy event-log tftp < ip-address > < filepath_filename >
copy event-log usb < filename >
copy event-log xmodem <filename>
These commands copy the Event Log content to a remote host,
attached USB device, or to a serially connected PC or UNIX
workstation.
For example, to copy the event log to a PC connected to the switch:

Copying Crash Data Content to a Destination Device

This command uses TFTP, USB, or Xmodem to copy the Crash Data content
to a destination device. You can copy individual slot information or the master
switch information. If you do not specify either, the command defaults to the
master data.
Indicates the operation is finished.
File Transfers
A-33