ProCurve 6200yl Management And Configuration Manual page 459

Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation
These commands copy the Crash Log content to a remote host,
attached USB device, or to a serially connected PC or UNIX
workstation. You can copy individual slot information or the
master switch information. If you do not specify either, the
command defaults to the master data.
For example, to copy the Crash Log for slot C to a file in a PC connected to
the switch:
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-14. Example of sending a Crash Log for Slot C to a File on an Attached PC
File Transfers
A-35