ProCurve 6200yl Management And Configuration Manual page 173

1. Go to VLAN 20.
2. Configure two additional
IP addresses on VLAN
20.
3. Display IP addressing.
Figure 8-4. Example of Configuring and Displaying a Multinetted VLAN
Figure 8-5. Example of Multinetting on the Default VLAN
N o t e
If you then wanted to multinet the default VLAN, you would do the following:
The Internet (IP) Service screen in the Menu interface (figure 8-1 on page 8-5)
displays the first IP address for each VLAN. You must use the CLI show ip
command to display the full IP address listing for multinetted VLANs.
Configuring IP Addressing
IP Configuration
8-9