Viewing The Current Dns Configuration; Operating Notes - ProCurve 6200yl Management And Configuration Manual

ProCurve# show ip
Internet (IP) Service
IP Routing : Disabled
Default Gateway : 10.28.192.2
Default TTL
Arp Age
Domain Suffix
DNS server
VLAN | IP Config
------------ + ---------- --------------- ---------------
DEFAULT_VLAN | Manual
Figure C-24. Example of Viewing the Current DNS Configuration

Viewing the Current DNS Configuration

The show ip command displays the current DNS configuration along with
other IP configuration information. If the switch configuration currently
includes a non-default (non-null) DNS entry, it will also appear in the show run
command output.
: 64
: 20
: pubs.outdoors.com
: 10.28.229.10
IP Address
10.28.192.1

Operating Notes

■ The DNS server must be accessible to the switch, but it is not neces-
sary for any intermediate devices between the switch and the DNS
server to be configured to support DNS operation.
■ A DNS configuration must include the IP address for a DNS server
that is able to resolve host names for the desired domain. If a DNS
server has limited knowledge of other domains, then its ability to
resolve ping or traceroute requests is also limited.
■ If the DNS configuration includes a DNS server IP address but does
not also include a domain suffix, then any ping or traceroute
command should include the target host's fully qualified domain
name. Refer to figure C-18 on page C-50.
■ The switch supports one DNS entry; that is, one DNS server IP address
and the corresponding domain name suffix.
DNS Resolver Configuration in the
show ip command output
Subnet Mask
255.255.255.0
Troubleshooting
Diagnostic Tools
C-55