Workstation; Copying Command Output To A Destination Device - ProCurve 6200yl Management And Configuration Manual

File Transfers
Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation
A-32
Copying Diagnostic Data to a Remote
Host, USB Device, PC or UNIX

Workstation

You can use the CLI to copy the following types of switch data to a text file in
a destination device:
Command Output: Sends the output of a switch CLI command as a file on
■
the destination device.
Event Log: Copies the switch's Event Log into a file on the destination
■
device.
■ Crash Data: software-specific data useful for determining the reason for
a system crash.
Crash Log: Processor-Specific operating data useful for determining the
■
reason for a system crash.
The destination device and copy method options are as follows (CLI key word
is in bold):
Remote Host via TFTP.
■
Physically connected USB flash drive via the switch's USB port.
■
Serially connected PC or UNIX workstation via Xmodem.
■

Copying Command Output to a Destination Device

Syntax: copy command-output < "cli-command" > tftp < ip-address > < filepath-
filename >
copy command-output < "cli-command" > usb < filename >
copy command-output <"cli-command"> xmodem
These commands direct the displayed output of a CLI
command to a remote host, attached USB device, or to a serially
connected PC or UNIX workstation.
For example, to use Xmodem to copy the output of show config to a serially
connected PC: