Lldp-Med Fast Start Control - ProCurve 6200yl Management And Configuration Manual

Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
14-56

LLDP-MED Fast Start Control

Syntax: lldp fast-start-count < 1 - 10 >
An LLDP-MED device connecting to a switch port may use
the data contained in the MED TLVs from the switch to
configure itself. However, the lldp refresh-interval setting
(default: 30 seconds) for transmitting advertisements can
cause an unacceptable delay in MED device configuration.
To support rapid LLDP-MED device configuration, the lldp
fast-start-count command temporarily overrides the refresh-
interval setting for the fast-start-count advertisement interval.
This results in the port initially advertising LLDP-MED at
a faster rate for a limited time. Thus, when the switch detects
a new LLDP-MED device on a port, it transmits one LLDP-
MED advertisement per second out the port for the duration
of the fast-start-count interval. In most cases, the default
setting should provide an adequate fast-start-count interval.
(Range: 1 - 10 seconds; Default: 5 seconds)
Note: This global command applies only to ports on which a
new LLDP-MED device is detected. It does not override the
refresh-interval setting on ports where non-MED devices are
detected.
Advertising Device Capability, Network Policy, PoE Status
and Location Data
The medTlvEnable option on the switch is enabled in the default configuration
and supports the following LLDP-MED TLVs:
LLDP-MED capabilities: This TLV enables the switch to determine:
■
• whether a connected endpoint device supports LLDP-MED
• which specific LLDP-MED TLVs the endpoint supports
• the device class (1, 2, or 3) for the connected endpoint
This TLV also enables an LLDP-MED endpoint to discover what LLDP-
MED TLVs the switch port currently supports.
network policy operating on the port to which the endpoint is connected
■
(VLAN, Layer 2 QoS, Layer 3 QoS)
■ PoE (MED Power-over-Ethernet)
■ physical location data — page 14-60