ProCurve 6200yl Management And Configuration Manual page 570

Troubleshooting
Debug and Syslog Messaging Operation
C-36
event
Configures the switch to send Event Log messages to the
configured debug destination(s). Note: This has no effect
on event notification messages the switch routinely sends
to the Event Log itself. Also, this debug type is automatically
enabled in these cases:
• If there is currently no Syslog server address configured
and you use logging < ip-addr > to configure an address.
• If there is currently at least one Syslog server address
configured and the switch is rebooted or reset.
ip
Enables all IP-OSPF message types for the configured des-
tinations.
lldp
Enables all LLDP message types for the configured destina-
tions.
Syntax: [no] debug < debug-type > (Continued)
ip [ ospf < adj | event | flood | lsa-generation | packet | retransmission
| spf > ]
For the configured debug destination(s):
ospf < adj | event | flood | lsa-generation | packet | retransmission
| spf > — Enables the specified IP-OSPF message type.
adj — Adjacency changes.
event — OSPF events.
flood — Information on flood messages.
lsa-generation — New LSAs added to database.
packet — Packets sent/received.
retransmission — Retransmission timer messages.
spf — Path recalculation messages.
ip [ rip < database | event | trigger > ]
rip < database | event | trigger > > — Enables the specified RIP
message type for the configured destination(s).
database— Display database changes.
event— Display RIP events.
trigger— Display trigger messages.
(Default: Event (log) message type.)
— Continued from Preceeding Page —