ProCurve 6200yl Management And Configuration Manual page 304

Hide thumbs Also See for 6200yl:

Table of Contents

Port Trunking

Trunk Group Operation Using LACP

Blocked Ports with Older Devices. Some older devices are limited to four

ports in a trunk. When eight LACP-enabled ports are connected to one of these

older devices, four ports connect, but the other four ports are blocked. The

LACP status of the blocked ports is shown as "Failure".

If one of the other ports becomes disabled, a blocked port will replace it (Port

Status becomes "Up"). When the other port becomes active again, the replace-

ment port goes back to blocked (Port Status is "Blocked"). It can take a few

seconds for the switch to discover the current status of the ports.

ProCurve(eth-B1-B8)# show lacp

Figure 12-11. Blocked Ports with LACP

Chapters

Table of Contents