Poe Event Log Messages - ProCurve 6200yl Management And Configuration Manual

Power Over Ethernet (PoE) Operation
PoE Operating Notes
Message
I < > <
MM/DD/YY HH:MM:SS
<chassis|ports>
Slot < slot-id > POE usage is below
configured threshold of < 1 - 99 > %
port < port-id > applying power to PD
port < port-id > PD detected
Slot <slot-id> software update
started on PoE controller
<controller-id>
Slot <slot-id> software update
completed on PoE controller
<controller-id>
11-30

PoE Event Log Messages

PoE operation generates these Event Log messages. You can also configure
the switch to send these messages to a configured debug destination (terminal
device or SyslogD server).
"Informational" PoE Event-Log Messages
>
Meaning
Message header, with severity, date, system time, and
system module type (chassis or ports). For more information
on Event Log operation, including severity indicators, refer
to "Using the Event Log To Identify Problem Sources" on
page C-26
Indicates that POE usage on the module in the indicated slot
has decreased below the threshold specified by the last
execution of the power threshold command affecting that
module. This message occurs if, after the last reboot, the
PoE demand on the module exceeded the power threshold
and then later dropped below the threshold value.
A PoE device is connected to the indicated port and
receiving power.
The switch has detected a PoE device connected to the
indicated port.
A module needs to have its PoE firmware updated and the
software begins the update process. On Series 5400zl
switches the controller-id is always "1"
A module has its PoE firmware updated and the software
has finished this process.