Copying Event Log Output To A Destination Device; Copying Crash Data Content To A Destination Device - ProCurve 2626 Management And Configuration Manual

File Transfers
Copying Diagnostic Data to a Remote Host, PC, or Unix Workstation
At this point, press
and start the
[Enter]
Xmodem command
sequence in your
terminal emulator.
Figure A-9. Example of Sending Event Log Content to a File on an Attached PC
At this point, press
and start the
[Enter]
Xmodem command
sequence in your
terminal emulator.
Figure A-10. Example of Copying Switch Crash Data Content to a PC
A-22

Copying Event Log Output to a Destination Device

This command uses TFTP or Xmodem to copy the Event Log content to a PC
or UNIX workstation on the network.
Syntax: copy event-log tftp < ip-address > < filepath and filename >
copy event-log xmodem
For example, to copy the event log to a PC connected to the switch:

Copying Crash Data Content to a Destination Device

This command uses TFTP or Xmodem to copy the Crash Data content to a PC
or UNIX workstation on the network. You can copy individual slot information
or the master switch information. If you do not specify either, the command
defaults to the master data.
Syntax: copy crash-data [< slot-id | master >] xmodem
copy crash-data [< slot-id | master >] tftp < ip-address > < filename >
slot-id = a - h, and retrieves the crash log or crash data from
where:
master Retrieves crash log or crash data from the switch's
For example, to copy the switch's crash data to a file in a PC:
the processor on the module in the specified slot.
chassis processor.