Table of Contents
Advertisement
NOTE:
It is possible to set up so that more than one Repeater acts as a relay for the same Remote Units.
However because wireless communication is carried out in Groups of Remote Units, the same Group
will be relayed through different Repeaters causing inefficiency and an increase in the amount of
communication time to more than necessary.
In order to reduce the communication time, please design Relay Routes so that a particular Group of
Remote Units uses the same Repeater(s).
NOTE:
A Repeater Number will be automatically assigned to Repeaters in the order that they were registered to
each Route.
Communication among Repeaters will occur in sequence from the one that is closest to the Base Unit.
Please keep that in mind when placing the Repeaters.
( EX:
Communication will occur sequentially from the first Repeater as shown above.
If the Repeaters are not arranged in numerical sequence from the Base Unit, the communication
route will be as seen below. This will cause not only the communication distance to increase but
also the communication time to increase to longer than necessary.
4.
After each Registration has been completed, please check the communication
status by carrying out a Wireless Communication Test from the [Repeater
Registration] Window under [Communication] - [Wireless Communication Test].
*If no Repeater is registered, the current data from all Remote Units will be gathered to
confirm the communication status.
43
Advertisement
Table of Contents
