T&D RTR-5W User Manual page 123

[Notification Test] Button
Use this to send a test mail from the RTR-5W to the notification address and confirm that
the warning notification settings are correct.
A notification test is successful if a notification test mail reaches the notification address.
If it does not reach the set address, please check the SMTP server, Notification Address,
and Sender Address settings.
If you are sending mail via the Internet, it is necessary to first make sure that your
network is properly connected to the Internet and you can send mail outside of your
network.
Depending on your operating environment, it may take some time before the mail is
received. (Especially if the address is a cell phone address.)
Before carrying out a notification test, it is necessary to make settings for the
following:
- There must be a check next to Warning ON and proper entries must be made for "Notification
Address" and "Sender Address".
- In the [Network Settings Utility], the SMTP server (mail server) must be assigned properly. (If
you have questions, see the information provided by your provider).
- It should be noted that if you assign an imaginary address, in some cases the SMTP server
will judge the mail to be SPAM or junk mail and not allow it to be sent. Please use your own
mail address.
Viewing the Warning Log : From ([View] – [View Log])
In the warning log will appear all warning occurrences.
Due to timing problems, there may be instances when a warning cannot be stored into
the computer. For details, see the Help for [RTR-5W for Windows].
The logs are in CSV format which can be read by common spreadsheet software and
saved as text file.
114