External Output; Connecting The Signal Wire; Removing An Input Signal Wire - T&D RTR-5W User Manual

External Output

■ Connecting the Signal Wire

1.
Prepare a Φ 0.5 to 0.9 single type wire and remove the covering to about 10mm
from the tip.
2.
Using a screwdriver or other such tools, while pressing down on the <terminal
Button B> at the back of the unit, insert the wire into the <hole A>.
Enlarged view of Wire
Connection Terminal

■ Removing an Input Signal Wire

If you wish to remove an input signal wire, press down on the <B> Button with a
screwdriver and pull out the wire.
NOTE:
Please be careful when pulling out the wire.
◆ External Output : With Warning ON
Voltage when OFF:AC/DC less than 50V
Current when ON:less than 0.1A
Resistance when ON:35 Ω
<A>
◆ Useable Wires
Compatible Wires : Single wire: Φ 1.0 (AWG18) / Twisted wire: 0.75mm
<B>
Useable Wires : Single wire: Φ 0.4 to Φ 1.0 (AWG26 to 18)
Standard Stripping Length : 0.39in
Compatible Connector Tool : Screwdriver (Shaft: Φ 0.3 / Blade Tip Width: 2.6)
Twisted wire:0.3 to 0.75mm
Cable core diameter: Φ 0.18
2
(AWG22 to 20)
2
18