Adjustment - T&D RTR-5W User Manual

Adjustment

Adjustment is a function used to make adjustments to Remote Unit measurements. By
making adjustments to measurements, the adjusted measurements will be displayed and
recorded. It is possible to select from two methods of adjustment: "1-point Adjustment"
and "2-point Adjustment". Adjustment will be based upon the simple equation: Y=aX+b.(X
equals the measured value and Y equals the value after adjustment.)）
The Adjustment Function can only be used with RTR-51/52/53/52PT, RVR-52A.
NOTE:
- The settings can be made only via optical communication
- We cannot guarantee that after carrying out adjustment the measuring accuracy will improve for all
measuring ranges.
- If you remove a sensor that was connected when adjustment was carried out and then connect a different
sensor, make sure to make new adjustment settings to reflect the actual situation.
- By making new adjustment settings to an already adjusted device the new adjustment equation will be
used to further adjust the previously adjusted result causing the difference to increase dramatically. Make
sure to click the [Initialize] button before making any new adjustment settings on already adjusted values.
- When carrying out adjustments and formulating equations please take care with the settings and take
personal responsibility for the process.
1.
Open [RTR-5W for Windows].
2.
From the Administration Tree, select the Remote Unit (only one at a time) for
which settings are to be made and place it face down on top of the RTR-5W.
3.
In the [Settings] Menu, select [Adjustment Settings (Optical Communication)].
NOTE (RVR-52A) :
- When measuring moisture with the RVR-52A, please make adjustment settings in [Settings] – [Moisture
Probe Settings] – [Moisture Adjustment].Under [Moisture Adjustment], check "Make Adjustment" and
enter the desired values. Click the [Use Adjustment in Equation] Button and the calculation equation will
be displayed.
119