Powtran PI9000 series User Manual page 163

4-stage
E1.04
setting 4X
5-stage
E1.05
setting 5X
6-stage
E1.06
setting 6X
7-stage
E1.07
setting 7X
8-stage
E1.08
setting 8X
9-stage
E1.09
setting 9X
10-stage
E1.10
setting 10X
11-stage
E1.11
setting 11X
12-stage
E1.12
setting 12X
13-stage
E1.13
setting 13X
14-stage
E1.14
setting 14X
15-stage
E1.15
setting 15X
The multi-stage command can be used as frequency source, can also act as the set source
of process PID. The dimension of multi-stage command is the relative values and its range is
from -100.0% to 100.0%, when it acts as the frequency source, it is the percentage of
maximum frequency; due to the PID reference is originally as a relative value, therefore the
multi-stage command acts as the set source of PID and does not need dimension conversion.
The multi-stage command needs to switch according to the different states of
multifunction digital DI, please refer to F1 group for specific instructions
Simple
E1.16
running mode
The figure is the schematic diagram of Simple PLC as the frequency source. For Simple
PLC as the frequency source, the positive or negative value of E1.00 to E1.15 determines the
running direction, the negative value indicates that the inverter runs at the opposite direction.
As the frequency source, PLC operates in three modes, including:
0: stop after single running
After the inverter completes a single cycle, it will automatically shut down , the running
command must be given before restart.
1: hold final value after single running
speed
-100.0% to 100.0%
speed
-100.0% to 100.0%
speed
-100.0% to 100.0%
speed
-100.0% to 100.0%
speed
-100.0% to 100.0%
speed
-100.0% to 100.0%
speed
-100.0% to 100.0%
speed
-100.0% to 100.0%
speed
-100.0% to 100.0%
speed
-100.0% to 100.0%
speed
-100.0% to 100.0%
speed
-100.0% to 100.0%
Stop after single running
PLC
Hold final value after single
running
Circulating
Chapter 5 Function parameter
157
0.0%
0.0%
0.0%
0.0%
0.0%
0.0%
0.0%
0.0%
0.0%
0.0%
0.0%
0.0%
0
0
1
2
☆
☆
☆
☆
☆
☆
☆
☆
☆
☆
☆
☆
☆