Powtran PI9000 series User Manual page 111

direction is determined by the state of DIy.
The terminal function is set as follows:
Terminals
DIx
DIy
DIn
To run, firstly close DIn terminal, the motor run signal is generated by the ascendant
edge of DIx, the motor direction signal is generated by DIy status
To stop, you must disconnect DIn terminal signals Of which, DIx, DIy and DIn are the
multi-function input terminals of DI1 to DI10, DIx is for active pulse, DIy and DIn are for
active level.
SB2
DIx
SB1
DIn
K
DIy
COM
Three-wire control mode 2
Of which:
SB1: Stop button
Terminal UP / DOWN
F1.11
change rate
Used to set terminal UP/DOWN adjustment frequency, the rate of frequency change, i.e.
frequency change amount per second.
When F0.02 (frequency decimal point) is 2, the value range is 0.001Hz/s to 65.535Hz/s.
When F0.22 (frequency decimal point) is 1, the value range is 0.01Hz/s to 655.35Hz/s.
Minimum input value
F1.12
for AI curve 1
Minimum input
F1.13
setting for AI curve 1
Maximum input for AI
F1.14
curve 1
Maximum input
F1.15
setting for AI curve 1
The above function codes are used to set the relationship between analog input voltage
and its representatives set value.
When the analog input voltage is more than the set Maximum Input (F1.14), the analog
voltage takes the Maximum Input as the calculated value, Similarly, when the analog input
voltage is less than the set Minimum Input (F1.12), according to the Setting Selection For AI
Less Than Minimum Input (F1.25), the analog voltage takes Minimal Input or 0.0% as the
calculated value.
When the analog input is the current input, 1mA current is equivalent to 0.5V voltage.
Set value
Forward
K
Three-wire
0
operation
Reverse
1
Digital common
SB2: Run button
0.01Hz/s to 65.535Hz/s
0.00V to F1.14
-100.00% to 100.0%
F1.12 to 10.00V
-100.00% to 100.0%
Chapter 5 Function parameter
1
2
3
Command
FWD
REV
105
Description
Forward run (FWD)
Reverse run (REV)
Three-wire operation
control
1.000Hz/s
0.00V
0.0%
10.00V
100.0%
☆
☆
☆
☆
☆