Powtran PI9000 series User Manual page 106

Chapter 5 Function parameter
23 PLC status reset
24 Wobbulate pause
25 Counter input
26 Counter reset
27 Length count input
28 Length reset
29 Torque control prohibited
High-speed pulse input
30
(only valid for DI5 )
Reserve
31
Immediately DC braking
32
External fault normally
33
closed input
34 Frequency change enable
PID action direction as
35
reverse
External parking terminal
36
1
Control command switch
37
terminal 2
38 PID integral pause
Switch
39
frequency source master
When PLC pauses and runs again, this terminal is
used to reset the inverter to the initial state of
simple PLC.
When the inverter outputs at center frequency.
Wobbulate will pause
Input terminal of the count pulse
Clear counter status
Input terminal of the length count.
Clear length
When the inverter torque control is prohibited, the
inverter will enter speed control mode.
DI5 is used as pulse input terminal.
Reserve
If the terminal is active, the inverter switches
directly to DC braking status
When the signal of external fault normally closed
input is inputted into the inverter, the inverter will
report fault Err.15 and shutdown.
If the function is set to be valid, when the
frequency changes, the inverter does not respond
to frequency changes until the terminal state is
invalid.
If the terminal is valid, PID action direction
opposites to the direction set by E2.03
Under keyboard control mode, the terminal can be
used to stop the inverter, same as STOP key on the
keyboard.
Used to switch between terminal control and
communication control. If the command source is
selected as terminal control, the system will be
switched to the communication control mode
when the terminal is active; vice versa.
When the terminal is active, the PID integral
adjustment function is paused, but the proportion
and differential adjustments of PID are still valid.
between
When the terminal is active, the frequency source
A is replaced by the preset frequency (F0.01)
100