Powtran PI9000 series User Manual page 134

Chapter 5 Function parameter
15 14 13 12 11 10
If the above parameters need to be displayed on operation, firstly set its position to 1,
and then set at F6.03 after converting the binary number to the hexadecimal number.
F6.04
Load speed display coefficient
When load speed needs to be displayed, adjust the inverter's output frequency and load
speed by using the parameter.
Decimal places for load speed
F6.05
display
Decimal places for load speed display The below example illustrates the calculation of
load speed:
If the load speed coefficient(F6.04) is 2.000, the number of decimal places of load
speed(F6.05) is 2 (two decimal places), when the inverter operating frequency reaches
40.00Hz, the load speed is : 40.00 * 2.000 = 80.00 (2 decimal places display)
If the inverter is shutdown, the load speed displays the speed relative to the set
frequency, that is the "set load speed". If the set frequency is 50.00Hz, the load speed under
the state of shutdown: 50.00 * 2.000 = 100.00 (2 decimal places display)
Inverter module radiator
F6.06
temperature
Display the inverter module IGBT temperature
The different models of the inverter module vary IGBT overtemperature protection
values.
F6.07
Total run time
Display the total run time of inverter When the run time reaches the set time(F7.21), the
inverter's multi-function digital output function (12) outputs ON signal.
F6.08
Total power-on time
F6.09
Total power consumption
Display the total power consumption of inverter to date until now
F6.10
Part number
9 8
Length
PLC range
Load speed
PID setting
High speed pulse
input frequency (Hz)
Remain
Remain
Remain
7 6 5 4 3 2 1
0.0001 to 6.5000
0 decimal
place
1 decimal
place
2 decimal
places
3 decimal
places
0.0 to 100.0
℃
0h to 65535h
0 to 65535 h
0 to 65535 kwh
Inverter
number
128
0
Setting frequency
(Hz)
Bus voltage
(V)
DI input situation
DO output situation
AI1 voltage (V)
AI2 voltage
(V)
Remain
Count value
3.00
00
0
1
1
2
3
-
℃
-
-
-
product
-
☆
☆
●
●
●
●
●