Step 2 Assemble I.v. Pole To Warming Unit - level 1 H-1200 115V Operator's Manual

d
e
f
g
c
h
Step 2
Assemble I.V. Pole to the Warming Unit
There are three steps involved in assembling the I.V. Pole to the
Warming Unit. The steps are: 1. Assemble the I.V. Pole to the Base,
2. Close the Drain Valve, and 3. Attach the Warming Unit to the
Flanking Brackets. Each step is detailed in a short procedure.
2.1 Assemble the I.V. Pole to the Base
1 Locate the I.V. Pole Base (
2 Locate the dark-gray extruded I.V. Pole (
b
3 Place the I.V. Pole Base upright on its wheels, (
4 Locate three bolts (
5 Align the three holes (
6 Slide the I.V. Pole down over the pole base, (
a
7 Guide three bolts and washers through the holes (
2.2 Close the Drain Valve
Turn valve, located on the bottom of the device, perpendicular to
stem (
S E C T I O N 5 • O u t o f t h e B o x — A s s e m b l y
Brackets.
wheels to prevent movement during set up.
) and washers for the pole base.
d
) in the I.V. Pole with the three screw
e
holes on the pole base.
aligned.
of the pole and tighten.
) of the Warming Unit as shown.
h
| Operator's Manual
).
a
) with Flanking
b
) and lock the
c
) keeping holes
f
) at the base
g
11