Step 3 Install The Pressure Chambers - level 1 H-1200 115V Operator's Manual

S E C T I O N 5 • O u t o f t h e B o x — A s s e m b l y
2.3 Attach the Warming Unit to the Flanking Brackets
1 Align the eight hex screws on the back of the Warming Unit
with the eight keyhole notches on the flanking bracket.
2 Slide screw heads down into keyhole notches.
3 Tighten all eight hex screws with the supplied hex
wrench and secure in place.
2.4 Attach the Quick Reference Guide to the
Fluid Warmer by sliding the ring on the
Quick Reference Guide over one of the
poles on the Flanking Bracket.
Step 3
Install the Pressure Chambers
1 Locate the two Pressure Chambers.
2 Locate the U-brackets and thumbscrews supplied with the
Pressure Chambers.
3 Attach the U-brackets with thumbscrews to the back of the Pressure
Chambers, as shown. Keep thumbscrews and brackets loose.
4 Slide one Pressure Chamber with attached U-bracket over the top
of each flanking pole.
5 Align the U-bracket slightly below the top of the flanking pole.
Tighten the thumbscrews securely.
12
| Operator's Manual