S E C T I O N 5 • O u t o f t h e B o x — A s s e m b l y
S E C T I O N
5
Out of the Box—Assembly
This device must be assembled and tested by authorized Smiths Medical
personnel, an authorized distributor of Smiths Medical, or competent
personnel prior to placing the device into service.
The following steps describe how to assemble and do preliminary set up of the
Level 1
®
H-1200 Fast Flow Fluid Warmer (Fluid Warmer).
Refer to Step 8 if you need to install the Level 1
Detector/Clamp to the Level 1
Step 1
Verify components of the Fluid Warmer
Step 2
Assemble I.V. Pole to Warming Unit
Step 3
Install Pressure Chambers
Step 4
Attach the I.V. Bag Hanger
Step 5
Disinfect the Recirculating Solution Reservoir
Step 6
Preliminary Preparation
Step 7
Connect the Pneumatic Tubing
Step 8
Install the Level 1
Step 9
Perform Electrical Safety Tests
Read through the instructions completely prior to setting up the device.
After unpacking the system, recycle packaging material according to
Note :
hospital policy for recyclable materials.
®
H-31, Version B, Air
®
H-1000 Fast Flow Fluid Warmer.
®
H-31, Version B, Air Detector/Clamp
| Operator's Manual
9