S E C T I O N 9 • O p e r a t i n g I n s t r u c t i o n s
If fluid exits in the Patient Line or the D/DI-60HL and D/DI-65HL
Disposable Set, replace the Disposable Set.
Open the pinch clamp below the Gas Vent/Filter Assembly.
2
Allow fluid to flow until no air is observed in the Patient Line and
3
the line is primed with fluid. Then, close the roller clamp on the
Patient Line.
On D/DI-60HL and D/DI-65HL Disposable Sets close roller
Note:
clamp below Drip Chamber.
D—Test the Audible and Visual Alarms
Test the visual and audible alarm signals by performing the
following steps.
Press and hold the Alarm Test button on the Fluid Warmer's
1
Power and Alarm Test Panel.
• All Fluid Warmer visual alarm LEDs illuminate
and the audible alarm signal beeps.
Release the Alarm Test button; the Over Temperature alarm
2
continues.
WARNING!
| Operator's Manual
43