OPTIMUM
M A S C H I N E N - G E R M A N Y
INFORMATION
Friction during the cutting process causes high temperatures at the cutting edge of the tool. The
tool should be cooled during the milling process. Cooling the tool with a suitable cooling
lubricant ensures better working results and a longer edge life of the cutting tool.
INFORMATION
Use a water-soluble and non-pollutant emulsion as a cooling agent. This can be acquired from
authorised distributors.
Make sure that the cooling agent is properly retrieved. Respect the environment when dispo-
sing of any lubricants and cooling agents. Follow the manufacturer's instructions for disposal.
4.9
Manual spindle sleeve feed with the fine feed
Turn the handle screw.
The spindle sleeve lever will move
towards the drill-mill head and will
activate the clutch of the fine feed.
Turn the spindle sleeve fine feed in
order to move the spindle sleeve.
4.10
Digital display for spindle sleeve travel
4.10.1
Technical data
Measuring range
Reading accuracy
Power supply
Page 32
Drilling-Milling machine
Handle screw
Fine feed
spindle sleeve
mm
0 - 999.9
inch
0 - 39.371"
mm
0.01
inch
0.0004"
round cell CR2032
3 V
�
20 x 3,2mm
BF 20 Vario ; BF 20 L Vario
Fig.4-7: Fine feed
Version 3.1.4
Operation
9 / 03 / 2010