Restarting; Inspection And Maintenance - Optimum BF20 L Vario Operating Manual

OPTIMUM
M A S C H I N E N - G E R M A N Y
"Disconnecting and securing the drilling-milling machine" on page 13
Position a warning sign.
5.1.2

Restarting

Before restarting, run a safety check.
"Safety check" on page 11
WARNING!
Before starting the drilling-milling machine you have to check that there is no danger for
the staff and the drilling-milling machine is undamaged.
5.2

Inspection and maintenance

The type and extent of wear depends to a large extent on individual usage and service condi-
tions. For this reason, all the intervals are only valid for the authorised conditions.
Interval Where?
Start of work,
after each
maintenance
or repair ope-
ration
Start of work,
after each
maintenance
or repair ope-
ration
Weekly
As required
Page 40 Drilling-Milling machine
What? How?
"Safety check" on page 11
Lubricate all slideways.
Lubricate
Lubricate all blank steel parts. Use acid-free oil, for
Lubricate
example weapon oil or engine oil.
An increased clearance in the spindles of the crosstable can
be reduced by readjusting the spindle nuts. Refer to spindle
nuts position 66 and 71
The spindle nuts are readjusted by reducing the flank of
Readjust
screw thread of the spindle nut with an adjusting screw. By
readjusting a smooth running move over the whole toolpath
is to be assured, otherwise the wear by friction between
spindle nut /spindle would increase considerably.
BF 20 Vario ; BF 20 L Vario
Maintenance
Version 3.1.4 9 / 03 / 2010