General Safety Instructions; Repair Service By The Manufacturer Or Commercial Agent - stayer SC300W Operating Instructions Manual

Electrical protective equipment
1.Class II electrical insulation.
2.Protective module for electrical grid failures so as
to avoid fortuitous starts of a machine after
recovery after a cut off of the electrical
supply.

18.General safety instructions

WARNING!
When using electrical tools, the essential safety
precautions should always be taken to reduce the
risks of fire, electrical shock and personal damages,
including the following.
Read these instructions with attention before using
this product, and store them.
19.Regular cleaning,
maintenance and greasing
Cleaning
Clean the machine starting with a brush or with a flat
brush so as to remove sawdust and with a soft cloth.
If compressed air is available, complete cleaning by
blowing with the compressed air pistol.
Maintenance
After each 2,000 hours of use or each two years the
electrical tool must be sent to the official technical
service for maintenance and complete revision.
Except for the operation of changing brushes, the
machine does not require any special maintenance
by the user. Keep the machine clean and use it
correctly. Regularly have the correctness of the
adjustments checked by a sufficiently trained user.
In the case of any failure, contact our technical
service.
ENGLISH
51
Changing brushes
IMAGES
Warning!
Always use the brushes as supplied by the official
technical service.
1.Remove screw 48.
2.Remove lid 51.
3.Remove screw 54.
4.Move pressing spring 55 to the left.
5.Extract used brush from the brush holder 53.
6.Insert new brush into the brush holder 53.
7.Place pressing spring 55 over the brush.
8.After applying the brush connector tighten screw
54.
9.Position lid 51.
10.Tighten screw 48.
Greasing
This machine does not require any specific
greasing by the user. Specific greasing of the
electrical tool will be carried out on the occasion of
the regular maintenance revisions at the official
technical service.
2 0 . R e p a i r s e r v i c e o f t h e
manufacturer or commercial
agent:
Stayer Ibérica S.A. Área Empresarial de Andalucía
- Sector 1, Calle Sierra de Cazorla No. 7. Postal
code: 28320 Pinto (Madrid) Spain.
51
T U V