Technical Specifications - stayer SC300W Operating Instructions Manual

Make it your custom to check that setting
keys and adjustable spanners are removed
from the tool before it is operated.
17. Avoid unintentional starting.
Make sure that the switch is in the "open"
position when plugging the machine into
the socket.
18.Use extensible cables for outside use.
When using the tool at an outside location,
only use extensible cables for outside use
that are marked for this purpose.
19.Be alert.
Look at what you are doing, use common
sense and do not work with the machine
when you are tired.
20.Check damaged parts.
Before using a tool again, it should be
carefully checked so as to determine that it
will operate suitably and be apt for the
operation which has been assigned to it.
Check the alignments and fixings of the

24.Technical specifications

Article
Model number
SC300W SC300W
SC310W SC310W
SC311W SC311W
SCE311W SCE311W
SC390W SC390W
SLL390W SLL390W
SC391W SC391W
SLL391W SLL391W
SC3000W SC3000W
The values given are valid for nominal voltages [U] of
and models for specific countries, these values can vary.
Please observe the article number on the type plate of your machines. The trade names of the individual
machines may vary.
Measure to be kept by saw blades:
Diameter of the saw blade: 305 mm
Thickness of the base disk: 1.8 – 2.8 mm
Hole diameter: 30 mm
Information on noise and vibration
The typical noise pressure level of the apparatus as
determined with an A-filter is: see table
ENGLISH
53
21.Warning:
22.Have the tool repaired by qualified personnel.
rpm
Absorbed
without load
power
2.000 4.200
2.000 3.000
2.000 3.000
2.000 1.500÷3.000
1.600 3.000
1.600 3.000
1.600 3.000
230/240 V ~ 50/60 Hz - 110/120 V ~ 60 Hz.
Wear ear protection!
The typical vibration transmitted to the hand / arm is
lower than 2.5 m/s .
53
movable parts, breakages of parts,
assembly and other conditions that may
affect the operation.
A damaged guard or other part should be
suitably repaired or replaced by an
authorized technical service unless
anything else is stated in the instructions
manual.
Have faulty switches replaced by an
authorized technical service.
Do not use the tool if the switch does not
switch on or switch off.
T h e u s e o f a n y a c c e s s o r i e s o r
s u p p l e m e n t s o t h e r t h a n o n e
recommended in this instructions manual
may generate personal damages.
This electrical tool complies with the
appropriate safety requirements. Repairs
should be carried out by qualified
personnel only using original spareparts;
otherwise, a considerable risk could be
generated for the user.
Noise K=3dB
Weight Protection
Kg Class
20 II
16.5 II
20 II
20 II
18.5 II
22 I
26 I
2
L L
pA wA
92 100
94 102
94 102
94 102
92 100
92 100
92 100
For lower voltage