Memory Channels, Memory; Setup - Kemppi Kempact Pulse 3000 Operation Instructions Manual

3.3.11. Memory channels, MEMORY

The pulse panel has 100 channels for different welding options. Memory channels can be chosen
on the lower part of the panel using the memory block. Both welding values and functions can be
saved. Do the following:
1. Press twice if needed and and the SET light will start blinking if the channel is not
in use, while the light will stay on if the channel is in use.
2. Select the memory channel you want by pressing CH button
3. Make settings and save by pressing SAVE button.
4. Press twice. ON light turns on.
5. Start welding and set the values.
To change the values, the light must be switched from the ON to SET and then you can choose the
parameters, pressing the SAVE button afterwards. It is also possible to save the used parameters by
pressing SET when memory function is OFF (no lights). The channel can be emptied by pressing
and SET button in SET simultaneously.
Using saved settings
1. Press button.
2. Select the memory channel by pressing the CH button.
3. Start welding.
Memory channels in control device
Select memory channels by pressing the CH REMOTE button simultaneously and the gun control
light will start to blink. Use the saved values through the gun's remote control.
You can use five channels.

3.3.12. SETUP

Using the SETUP function, the user can change welding parameters which do not have their own
panel functions. These parameters can be set separately for 1-MIG and Pulse MIG. SETUP settings
are separate for each memory channel.
© Kemppi oy Kempact pulse 3000, Kempactcool 10 / 0813 – 1