Panel; Choosing Start Switch Function; Choosing The Welding Method - Kemppi Kempact Pulse 3000 Operation Instructions Manual

3.3. PANEL

3.3.1. Choosing start switch function

MIG welding by 4-function start switch, MIG 4T
MIG welding by 2 function start switch, MIG 2T

3.3.2. Choosing the welding method

Normal MIG/MAG welding:
with a separate wire feed and voltage regulation can be chosen in the 1-MIG position.
Curve number "00" provides a free wire feed range between 1-18 m/min. The voltage
can be set between special pre-programmed limits depending on the wire feed. Curve
number "01" wire feed speed and voltage are not depended on each other. When curve
"01" is selected, the wire feed speed and voltage will be independent of one another.
Synergic MIG/MAG welding (1-MIG)
Synergic MIG/MAG welding (1-MIG): MIG welding in which the wire feed speed
determines all the other welding parameter values, allowing the adjustment of welding
power with a single knob. Choose the appropriate synergy curve for the filler wire and
shielding gas to determine how the wire feed speed affects the pulse parametres.
Synergic Pulse MIG welding:
through this welding method, based on pulsing the welding current, the filler metal on the
workpiece is kept spatter-free. The power source pulse parameters change automatically
(synergy) enabling welding power regulation using a single knob. Choose the appropriate
synergy curve for the filler wire and shielding gas to determine how the wire feed speed
affects the pulse parametres.
Double pulse:
the wire feed will become higher or lower according to the wire feed range. While the
synergic welding parameters change to correspond to the momentary wire speed. The
purpose is to get a goodlooking weld and a proper penetration while improving the
controllability of the weld pool during position welding.
1 – Kempact pulse 3000, Kempactcool 10 / 0813 © Kemppi oy