Commissioning; Safety Instructions For Commissioning; Overview Of The Commissioning - Siemens G120P Technical Manual

Variable speed drive

Hide thumbs Also See for G120P:

Operating instructions manual (496 pages)

Instruction manual (100 pages)

Hardware installation manual (94 pages)

Table Of Contents

Table of Contents

Commissioning

Safety instructions for commissioning

6 Commissioning

6.1 Safety instructions for commissioning

6.2 Overview of the commissioning

50 | 98

Siemens

Building Technologies

WARNING

Risk of injury due to uncontrolled movements!

Loads can move uncontrollably when the connected motor is switched on for the

purpose of motor data identification. These movements can cause serious injury.

●

Before switching on, check that no parts are loose on the machine or can be

spun out.

●

Before switching on, ensure that nobody is working on the machine or located

within the hazardous area around the machine.

●

Take measures to prevent unauthorized access to the hazardous area around

the machine.

●

Lower hanging/suspended loads to the floor.

For detailed information about the commissioning process, please refer to chapter

"Commissioning" in the Operating Instructions for the Control Unit

(A5E34257946A AB).

The process of commissioning a variable speed drive involves the following steps.

Please carry these out in the specified sequence:

Step

Activity

Define the requirements to be met by the

drive for your application [➙ 51].

Restore the factory settings on the variable

speed drive if necessary [➙ 60].

Check whether the factory setting of the

drive is appropriate for your application. If

not, start basic commissioning [➙ 51].

Check whether you need to adapt the

functions of the terminal strip that you

specify in the basic commissioning.

If necessary, adapt the communications

interface in the variable speed drive

[➙ 55].

If necessary, set further functions in the

variable speed drive [➙ 60].

Save your settings [➙ 64].

Fill out the commissioning log and enclose

it with the plant documentation [➙ 96].

Additional information

●