Application Examples; Universal Application - Siemens G120P Technical Manual

Application examples

7

Universal application

7 Application examples
7.1 Universal application
● Macro 101 "Universal application"
● Setpoint via a 0...10 V signal
● Analog setpoint can be overridden with 3 fixed speeds
● Flying restart and automatic restart activated
● Essential service mode (in the event of fire) with a
fixed setpoint
● Error message: Digital output 0
● Status display: Digital output 2
Notice:
In the case of the extended emergency mode, the customer
can no longer lodge any claims for warranty. Extended
emergency mode and the faults which arise during this
mode are logged in a password-protected memory and can
be read by the repair center.
Parameter Value
p731 r52.2
p756[0] 0
p840[0] r20047.0
p1000[0] 32
p1001[0] 800 rpm
p1002[0] 1000 rpm
p1003[0] 1200 rpm
p1015[0] 1500 rpm
p1020[0] r722.3
p1021[0] r722.4
p1022[0] r722.5
p1071[0] r20220
p1113[0] 0
p1200[0] 1
p1210 26
p2103[0] 0
66 | 98
Siemens
Building Technologies
Basic commissioning (Carrying out basic commissioning [➙ 51]) is a prerequisite
for the implementation of the application examples. During basic commissioning,
the applications below can be parameterized directly via the macro parameter
p0015. If the applications have to be set subsequently, the device must be set to
commissioning state.
Example: p0010 = 1 → p0015 = 101 → p0010 = 0
Description
Signal source for terminal DO 1
Unipolar voltage input (0...10 V)
ON / OFF (OFF1)
Speed setpoint selection
Fixed speed setpoint 1
Fixed speed setpoint 2
Fixed speed setpoint 3
Fixed speed setpoint 15
Fixed speed setpoint selection bit 0
Fixed speed setpoint selection bit 1
Fixed speed setpoint selection bit 2
Main setpoint scaling
Setpoint inversion
Flying restart always active (start in setpoint direction)
Acknowledging all faults and restarting for an ON command
Acknowledge faults
A5E36496664A_d
2016-03-17