Table of Contents
Advertisement
For only the European version:
When you turn ON the transceiver, "Model" screen is displayed depending on the
setting. Select the country where you operate the transceiver.
L If no country is selected, "General" is automatically selected.
■ Entering the MMSI code
The Maritime Mobile Service Identity (MMSI: DSC self ID) code consists of 9 digits.
You can only enter the code when turning ON the transceiver for the first time.
This initial code can be entered only once.
If your MMSI code has already been entered, doing the steps below is not necessary.
1.
Hold down [PWR] to turn ON the transceiver.
• Three short beeps sound, and "Push [ENT] to Register
your MMSI" is displayed.
2.
Push [ENT] to start entering the MMSI code.
• The "MMSI INPUT" screen is displayed.
L Push [CLEAR] twice to skip the entry. If you skip the
entry, you cannot make a DSC call. To enter the code
after skipping, turn OFF the power, and then turn it
ON again.
3.
Enter the MMSI code.
TIP:
• Select a number using [◄] and [►].
• Push [ENT] or [CH/ENT] to enter the selected
number.
• Select "←" or "→" on the screen, or rotate
[CH/ENT] to move the cursor.
4.
Repeat step 3 to enter all 9 digits.
5.
Select
Next
and push [ENT] or [CH/ENT] to set the
entered code.
• The "MMSI Confirmation" screen is displayed.
6.
Enter your MMSI code again to confirm.
Finish
7.
Push
to set the entered code.
• When your MMSI code is successfully entered, "MMSI
registered successfully." is briefly displayed, and then
enters the operating screen.
L Your MMSI code is also displayed on the opening
screen.
PREPARATIONS
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
8
Advertisement
Table of Contents
