It 1911I To Usb Interface (Com Port Emulation) - Leuze electronic 1910i Technical Description

5.6 IT 1911i to USB interface (COM port emulation)

The operation of the IT 1911i as a serial interface on a USB port is described in this chapter. A COM interface
is emulated in this operating mode. The data which are read in are sent to a new COM interface. The driver
with which you emulate this COM interface can be downloaded from our homepage at www.leuze.com. Thus,
the data can be processed further in programs which expect data via COM interfaces.
Required parts:
1x 50122434 IT 1911i ER-3
1x 50122431 Base station IT 1911i
1x 50114521 KB USB-1 IT190x
1x 50123862 Power supply unit
Please connect the base station acc. to the figures below.
To do this, proceed as follows:
1. Install the USB serial driver for the IT 1911i.
2. Connect the cable for the base station to a free USB
port.
3. The scanner acknowledges this connection with an
acoustic signal.
4. Scan the code shown below.
5. Open a terminal program or your program for the serial interface, select the new COM port, and make the
following settings: baud rate 115200, 8 data bits, 1 stop bit and no parity. A CR is transmitted as suffix (or
terminator).
NOTICE
To charge the IT 1911i, the power supply unit must be plugged in and the hand-held scanner placed in the
base station.
Leuze electronic
or 50114523 KB USB-2 IT190x
IT1911i 21