Hfm 3500D With Usb (Com-Port-Emulation); Triggering /Activation - Leuze electronic HFM 3500D Short Description

HFM 3500D with USB (COM-Port-Emulation)

To use the HFM 35xxD with USB you use the standard RS232 cable from the Base Hx520 and connect the
USB Converter cable. The Data is sent to the new COM-Port. The necessary driver is available on
www.leuze.de. the interface is set to 9600,8,N,1.Separate power supply needed.
Necessary parts:
1x 50110552 HFM 3500D, incl. RS232 -cable
1x 50110676 NT Hx5x0, Power supply(100-240VAC/6VDC)
1x 50110677 KB-USB-RS232, converter cable, 1m
USB-converter cable KB-RS232-USB, Length 1m
Pinning of the USB-connector, 9 pin Sub-d like above
Note: Operation with external power supply recommended
USB-Type A-Plug
1
2
3
4

Triggering /Activation

For starting the SCAN operation / activation signal (trigger) you use the Trigger button at the handle of the
device.
Short description HFM 3500D
Signal
VCC IN
Data -
Data -
GND
Leuze electronic
Art-No. 50110677
Description
5 VDC
Data -
Data +
Signal Ground
Page 19