Installation; Switching Off The Pc; Connecting The Base Station; Connecting To Base Station It 1911I - Leuze electronic 1910i Technical Description

2 Installation

2.1.1

Switching off the PC

NOTICE
Make sure that the PC is switched off before connecting the scanner.

2.2 Connecting the base station

Shown in the figure below are the locations for installing the cable on the base station.
2.2.1

Connecting to base station IT 1911i

1. To secure the connection cable to the base station, proceed as follows: Insert the RJ 41 connector into
the socket on the bottom of the base station until the cable clicks into place.
2. Connect the other end of the connection cable to the appropriate connection socket on the PC.
3. You may need a power supply unit for voltage supply if you would like to charge the hand-held scanner at
the base station or if you use an RS 232 interface. Use the pin assignments (see page 8) to select the
appropriate cable for your application.
4. Connect the power supply unit to the power socket.
5. Configure the hand-held scanner using the codes for the corresponding application; see chapter
"5 Configuration" or the external document "User's Guide IT 1910i/1911i".
Leuze electronic
Connection for power supply unit
Connection for interface cable
IT1911i 6